| General Display Messages |
|
| OFF |
Instrument has been powered OFF |
| bAt |
Indicates battery charge is low |
| bLo |
Indicates that the instrument is waiting for a sample to be provided |
| Flo/Lo |
Indicates that during the provided sample flow rates below the minimum allowed flow rate were detected |
| Flo/Hi |
Indicates that the provide sample had flow rates greater than the maximum allowed flow rate |
| Flo/InS |
Indicates that the flow rate was too inconsistant to be considered a valid sample |
| Flo/Cut |
Indicates that the sample was abruptly stopped at the end of the blow resulting in an invalid sample |
| POS |
This is a non-digital result indicating that the measured alcohol concentration was at or above the POSITIVE cutoff |
| NEG |
This is a non-digital result indicating that the measured alcohol concentration was below the POSITIVE cutoff |
| PAS |
This is a non-digital result indicating that the measured alcohol concentration was below the CAUTION cutoff |
| CAU |
This is a non-digital result indicating that the measured alcohol concentration was below the FAIL cutoff |
| Fail |
This is a non-digital result indicating that the measured alcohol concentration was equal to or above the FAIL cutoff |
|
|
| Status Messages |
|
| E03 |
Sensor Blank Timeout (> 60 seconds). Too long to establish Fuel Cell Baseline. |
| E06 |
Insufficient Sample. Subject unable to provide adequate sample on preset number of allowed sample attempts – normally 3 attempts. |
| E07 |
Calibration Failed (unable to calibrate – usually due to a sample out of range). Too low/high of Fuel Cell output difference from last calibration. |
| E09 |
Temp too Cold for Test Type Being Performed. |
| E10 |
Temp too Hot for Test Type Being Performed. |
| E11 |
Failed Air Blank – Replace mouthpiece with new mouthpiece and begin test again. |
| E12 |
Invalid Sample – instrument detected an anomaly in the fuel cell wave form during analysis and aborted test sequence. Could be RFI |
| E21 |
Fuel Cell leak detected |
| E22 |
Invalid Calibration Target (less than .040 or greater than .400 |
| E23 |
Memory Failure |
| E24 |
Suck back detected |
| E25 |
Voltage low on Reset Solenooid |
| E26 |
Excessive voltage on Reset Solenoid |
| E27 |
Insufficient drive voltage to sample. |
| E28 |
Excessive Voltage After Sample |
| E29 |
Fuel Cell Signal Clipping Condition – Fuel Cell reading exceeded A/D maximum range. |
| E30 |
Pressure Sensor Baseline Error |
| E31 |
Result Over Range – Fuel cell result greater than configured maximum reading. |
| E32 |
Internal Error – normally hardware or firmware related. |
|
|
| Settings/Options Menu |
|
| rcL |
Recall last test result |
| PAS |
Passive Testing option |
| rbL |
Road block or Quick Test option |
| ACC |
Accuracy Check |
| CAL |
Calibration Adjustment |
| dSr |
Display Software Revision identifier |